TTRS Forge intercooler fitment?
#1
Posted 02 February 2018 - 04:38 PM
#2
Posted 02 February 2018 - 04:43 PM
Attached Files
#3
Posted 02 February 2018 - 07:00 PM
well its quite different to that of the RS3 version in terms of how it mounts and it doesn't cut into the crash bar, however the pipe fitment is the same.
#4
Posted 02 February 2018 - 07:02 PM
6EFCFE91-5168-4FB0-8359-6A871A73E3B7.jpeg 71.47K 9 downloads
This was mine when being fitted. Note the different mounting points
#5
Posted 02 February 2018 - 11:31 PM
The standard intercooler on the 8J RSTT & 8P RS3 are the same but the Forge one's are types specific mate.
Dell.
#6
Posted 03 February 2018 - 11:22 AM
The standard intercooler on the 8J RSTT & 8P RS3 are the same but the Forge one's are types specific mate.
Dell.
Could I not get the mounting brackets/holes welded into place of the RS3 then? I know a guy 😉. Does yours have the standard crash bar or a modified version?
#7
Posted 03 February 2018 - 11:37 AM
#8
Posted 03 February 2018 - 01:52 PM
That TTRS one looks shorter than the RS3 one but slightly thicker so I really don’t think it’s going to fit at all like. Used RS3 ones pop up for about £700 with the crash bar. I wouldn’t use a chopped crash bar as it has almost zero strength without the extra piece welded in by Forge.
Just remember you have an Expensive car, don’t take shortcuts or it could be majorly expensive to repair
#9
Posted 03 February 2018 - 05:01 PM
There is pretty much zero gap behind the bumper and radiators. 5mm or so maximum.
That TTRS one looks shorter than the RS3 one but slightly thicker so I really don’t think it’s going to fit at all like. Used RS3 ones pop up for about £700 with the crash bar. I wouldn’t use a chopped crash bar as it has almost zero strength without the extra piece welded in by Forge.
Just remember you have an Expensive car, don’t take shortcuts or it could be majorly expensive to repair
Arkious.
Right on all counts mate.!
Dell.